Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
- Engine
   - Removal/installation of the power unit, dismantle of components
      General information
      Removal and engine installation
      Removal and installation of a cover of a head of cylinders
      Removal and installation of assemblies of a drive of valves
      Removal and thermostat installation
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal and turbokompressor installation
      Removal and installation of a radiator of system of cooling (all models)
      Removal and installation of the fan of system of cooling of the engine
      Removal and installation of the water pump
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal and installation of the oil pump
      Removal and installation of a damper of krutilny fluctuations of a cranked shaft
      Removal and installation of a cover of a drive of GRM and gas-distributing belt
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of a drive of valves, check of a condition of components
      Removal and installation of a balancing shaft
      Replacement of a back epiploon of a cranked shaft
      Removal and flywheel installation / driving disk
   + Regenerative repair of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and flywheel installation / driving disk

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove transmission.
3. On models from RKPP remove coupling assembly (see. Head Coupling and transmission line).

4. Mark the provision of a flywheel / a driving disk of rather cranked shaft and turn out fixing bolts.

5. On models from AT remove the adapter of a driving disk.

6. Remove a flywheel / a driving disk from the engine.


Installation

 PERFORMANCE ORDER

1. Grease fixing bolts with special hermetic for fixing of carving connections.

2. Connect flywheel assembly / a driving disk to a flange of a cranked shaft.
3. On models from AT establish the adapter of a driving disk.
4. Screw fixing bolts and tighten them with demanded effort (135 H • м: for models of 1.5 l; 130 ÷ 140 H • м: for models of 1.6 l, 2.0 l and 2.4 l; 100 H • м: for models of 1.8 l and 53 ÷ 56 H • м: for models of 3.0 l and 3.5 l).
5. On models from RKPP establish into place coupling assembly (see. Head Coupling and transmission line).
6. Establish transmission.
7. Connect a negative wire to the battery.