Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
Specifications
Coupling - the general information and check of a condition of components
Removal, check of a condition and installation of components of assembly of coupling
Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
Check of a condition and replacement of the directing bearing
Adjustment of a pedal of coupling
Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Air removal from a hydraulic path of a drive of switching off of coupling
Removal and installation of power shafts
Hinges of power shafts - the general information and service
Check of a condition of the transmission line
Removal and driveshaft installation
Replacement of the kardanny hinge
Driveshaft balancing
Removal and installation of assembly of the central bearing of the driveshaft
Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
Replacement of an epiploon of a leading gear wheel of back differential
Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Coupling and transmission line
General information The present Head is devoted to the transmission components located between a back part of the engine and lobbies (all models) and back (AWD model) by car wheels (without a transmission and a transfer case which are considered in Head the Manual transmission). According to the destination considered components can be broken into three categories: coupling, driveshaft and semi-axes / power shafts. Descriptions of a design and a principle of action of each of separate knots, and also procedures of check of a condition, removal, dismantling and regenerative repair of components entering into all three groups are provided in below-mentioned Sections.
As the most part of procedures described in the present Chapter is made under the car, it is necessary to give special attention to reliability of fixing of the last in the lifted situation. |
|
