Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
- Engine
   - Removal/installation of the power unit, dismantle of components
      General information
      Removal and engine installation
      Removal and installation of a cover of a head of cylinders
      Removal and installation of assemblies of a drive of valves
      Removal and thermostat installation
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal and turbokompressor installation
      Removal and installation of a radiator of system of cooling (all models)
      Removal and installation of the fan of system of cooling of the engine
      Removal and installation of the water pump
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal and installation of the oil pump
      Removal and installation of a damper of krutilny fluctuations of a cranked shaft
      Removal and installation of a cover of a drive of GRM and gas-distributing belt
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of a drive of valves, check of a condition of components
      Removal and installation of a balancing shaft
      Replacement of a back epiploon of a cranked shaft
      Removal and flywheel installation / driving disk
   + Regenerative repair of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of a forward epiploon of a cranked shaft

Originators of the real Management recommend to make replacement of a forward epiploon of a cranked shaft during performance of procedures of removal/installation of a gas-distributing belt (see. The section Removal and installation of a cover of a drive of GRM and a gas-distributing belt) as dismantle of an epiploon is not obviously possible without preliminary removal of a belt.


 PERFORMANCE ORDER

1. The epiploon is located under a cogwheel of a cranked shaft. Measure depth of landing of an old epiploon in the nest.
2. The epiploon is taken from the landing nest in a forward cover by a poddevaniye by the special tool.
3. Carefully smooth out contact surfaces of a nest of an epiploon.

4. As an opravka for landing of an epiploon it is possible to use a face head suitable the size, or a piece of a pipe of the corresponding diameter.

5. Track, that the epiploon was planted in a nest strictly on a certain depth.