Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
- Engine
   - Removal/installation of the power unit, dismantle of components
      General information
      Removal and engine installation
      Removal and installation of a cover of a head of cylinders
      Removal and installation of assemblies of a drive of valves
      Removal and thermostat installation
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal and turbokompressor installation
      Removal and installation of a radiator of system of cooling (all models)
      Removal and installation of the fan of system of cooling of the engine
      Removal and installation of the water pump
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal and installation of the oil pump
      Removal and installation of a damper of krutilny fluctuations of a cranked shaft
      Removal and installation of a cover of a drive of GRM and gas-distributing belt
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of a drive of valves, check of a condition of components
      Removal and installation of a balancing shaft
      Replacement of a back epiploon of a cranked shaft
      Removal and flywheel installation / driving disk
   + Regenerative repair of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement of a back epiploon of a cranked shaft

Details of installation of a back epiploon of a cranked shaft (all models)

1 — Adapternaya a plate
2 — the Landing plate
3 — the Back plate
4 — an epiploon Casing
5 — the Epiploon
6 — Bolts of fastening of a cover of bearings
7 — the Cover of bearings
8 — the Persistent bearing A

9 — the Persistent bearing
10 — Nizhny the loose leaf of the radical bearing
11 — the Cranked shaft
12 — the Persistent bearing B
13 — the Persistent bearing A
14 — the Top loose leaf of the radical bearing
15 — the Block of cylinders


Removal

 PERFORMANCE ORDER

1. Details of installation of a back epiploon of a cranked shaft are shown on an illustration.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. Remove transmission.
4. Remove flywheel assembly / a driving disk (see. Section Removal and flywheel installation / driving disk).
5. Remove a back plate and a transmission dome.
6. If leaks through a casing of a back epiploon take place, remove a casing. If a casing as it should be, simply take from it an epiploon.

On some engines the separator which also is subject to removal is in addition established.


Installation

 PERFORMANCE ORDER

1. Grease internal sponges of a new epiploon with pure impellent oil.
2. By means of the special adaptation of the MD998376 type press an epiploon in a casing against the stop, - track, that the epiploon did not appear is overwound. At the corresponding complete set plant in a casing a separator (an oil opening down).
3. Put hermetic on an interfaced surface, replace sealing laying and establish an epiploon casing on the block.
4. Establish flywheel assembly / a driving disk and transmission.
5. Connect a negative wire to the battery. Start the engine and check it on existence of signs of development of leaks.
6. Check level of impellent oil. In case of need make the corresponding adjustment (see. Head of Control and routine maintenance).