Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and precautionary measures
   Serviceability check functioning/adjustment of system of ignition
   Check of a condition and coil replacement (ек) ignitions
   Removal and installation of the key transistor (ignition module)
   Removal and installation of the distributor of ignition (model with contactless system of ignition)
   Removal and installation of sensors of provision of cranked and distributive shaft
   Check and adjustment of installation of a corner of an advancing of ignition
   Ignition order
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Check of serviceability of functioning, removal and generator installation
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Engine electric equipment

General information and precautionary measures

The structure of electric equipment of the engine includes components of systems of ignition, a charge and start. In view of that these systems have a direct bearing on operation of the engine, they are considered separately from other onboard electric equipment (such as lighting devices and monitors, etc.), Head Onboard electric equipment is devoted to placement, a design and which principles of functioning.

At service of components of systems of electric equipment it is necessary to observe special precautionary measures in order to avoid risk of failure of semi-conductor elements, and also for the purpose of receiving prevention элеткротравм. Remember that the generator and a starter are directly connected to the battery and in case of an overload or short circuit can become a cause of the fire. Try not to allow hits of hair and free fragments of clothes in a driving belt of the generator.

Starting electric equipment service surely remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to receiving electric shock or a strong burn.

Do not allow polarity violation at battery connection. In structure of such components as the generator, or electronic control units enter semi-conductor elements which can be put out of action at the wrong connection of wires.

At performance of start of the engine from the external power supply, or charger connection also observe polarity of connection of wires.

Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine.
Do not allow a provorachivaniye the engine of the disconnected generator.

At all do not make stock-taking of target tension of the generator by grounding of its plugs.

Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo car.

At performance of any works on service of electric equipment watch, that the negative wire was disconnected from the battery.

Before use of electroarc welding without fail disconnect the battery, the generator and such components, as food/ignition ECM systems in order to avoid risk of their damage.