Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
- Brake system
   Specifications
   Replacement of the sensor switch of stoplights
   Removal and GTTs installation
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning/tightness, removal and installation of the vacuum amplifier of brakes
   Removal and valve regulator installation
   Removal and installation of brake lines
   Pumping of brake system
   Disk brake mechanisms - the general information
   Assessment of a condition of brake shoes
   Replacement of blocks of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Regenerative repair of a support of the disk brake mechanism
   Removal, check of a condition and installation of a brake disk
   Drum-type brake mechanisms - the general information
   Removal, installation and check of a condition of a brake drum
   Check of a condition of brake boots
   Removal and installation of brake boots
   Adjustment of drum-type brake mechanisms
   Removal, regenerative repair and installation of wheel cylinders
   Removal and cable installation (ов) drive of the parking brake
   Adjustment of the parking brake
   Removal and installation of frictional boots of the parking brake (model with disk brake mechanisms of back wheels)
   System of anti-blocking of brakes (ABS) - the general information, problem diagnostics and codes of malfunctions
   Removal and installation of the hydraulic modulator
   Removal and ABS control unit installation
   Removal and installation of wheel sensors
   Removal and installation of sensors of accelerations (G-sensors)
   Replacement of rotors of wheel sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and valve regulator installation

Brake liquid is among aggressive chemical compounds and at contact to body panels destroys a paint and varnish covering. Before starting performance of procedure cover wings and the panel of a front of the car with special covers, or simply old blankets.


Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Find the valve regulator which has been usually located under assembly of GTTs.
3. Mark and disconnect the brake lines connected to the valve.
4. Remove the valve regulator and take it from an impellent compartment of the car.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down.
2. In summary do not forget to pump over brake system (see. Section Pumping of brake system).
3. Connect a negative wire to the battery and check serviceability of functioning of brakes.