Mitsubishi Galant

1. Location and details of installation of assembly of ECU ABS is shown on illustrations.
2. Switch off ignition.

Ignition should remain switched off during all time of performance of procedure.

3. On the Galant and Diamante models remove the left lateral panel of an upholstery of a luggage compartment.
4. On the Mirage models remove floor section of the central console.
5. Release a clamp in the lower part of the multicontact socket and disconnect electroconducting from the ABS control unit (ECU).
6. Give fixing nuts and remove ECU from the basic arm. In case of need the arm also to be dismantled by m.

1. If removed, establish into place a basic arm of the control unit.
2. Establish the control unit and strongly tighten nuts of its fastening.
3. If removed, connect to an arm the grounding tire, - grounding should be restored before connection to electroconducting ECU. Make sure of reliability of fixing of the contact plug.
4. Connect to the control unit the multicontact socket of electroconducting, - track reliability of a zashchelkivaniye of a clamp.
5. Establish the panel of an upholstery of luggage office / floor section of the central console.