Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of the main cylinder of coupling

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove located in an impellent compartment and blocking access to assembly of the main cylinder of coupling components.
3. Get under the car suitable capacity and prepare rags for collecting spilling at a detachment of hydraulic lines of liquid.
4. Release the shtutserny socket of the hydraulic line brought to the cylinder and merge from it liquid in the prepared capacity.

The liquid merged from a path is not subject to a reuse and should be utilized according to regional laws on environmental protection. Remember also that hydraulic liquid is an aggressive chemical compound and is capable to damage LKP at hit on the painted body surfaces!

5. Disconnect a cutting finger of fastening of a pusher of the cylinder to a coupling pedal. Remove a washer and disconnect a pusher.
6. Give the sensor switch fixing nuts and remove cylinder assembly from a back partition of an impellent compartment.

Between a landing flange of the cylinder and an interfaced surface of a partition sealing laying subject to replacement is established.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. Do not forget to grease all contact and basic knots.
2. Having finished assembly, "pump over" a hydraulic path, having completely removed from it air jams (see. The section air Removal from a hydraulic path of a drive of switching off of coupling).