Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)

Removal

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props.
2. Merge from differential transmission oil and remove the central section of system of production of the fulfilled gases.
3. Mark adjusting situation and disconnect from differential the back end of the driveshaft (see. Section Removal and driveshaft installation).
4. Remove semi-axes (see. The section Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)).
5. At the corresponding complete set remove assembly of the steering pump of a steering drive of back wheels.
6. On big bolts of fastening of a basic plate of differential to the bottom of the car can be used самоконтрящиеся nuts. Before giving nuts, prop up differential on the center a telezhechny jack. Release nuts and remove from a back part of a box of differential a basic plate (ы) and a vibrating damper of a square form.
7. Omit assembly of differential and take it from under the car.


Installation

 PERFORMANCE ORDER

1. Get differential on the regular place and screw bolts of a bearing beam. Replace everything самоконтрящиеся nuts.
2. At the corresponding complete set establish into place the pump of a steering drive of back wheels.
3. Having replaced lock rings, establish back semi-axes.
4. Establish the driveshaft.
5. Establish the central section of system of production of the fulfilled gases with the exhaust silencer.
6. Lower the car on the earth.
7. Fill in in a case of differential fresh transmission oil.