Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of assembly of the central bearing of the driveshaft

Removal

 PERFORMANCE ORDER

1. Mark position of the universal hinge of Lobro (Lobro) of rather connecting flange.
2. Turn out fixing bolts and separate the hinge from a flange.
3. Mark the provision of the central collar of rather central section of the driveshaft, and situation soyedinitelno a flange - rather back section.
4. Give самоконтрящиеся nuts and remove the central collar with a connecting flange.
5. Mark the provision of a forward arm of the central bearing of rather central section of a shaft, back - rather back section. Remove a basic arm of the central bearing.

Rubber pillows from an arm are not taken.

6. By means of a special stripper liberate from assembly forward and back central bearings.


Installation

 PERFORMANCE ORDER

1. Fill in forward and back flutes of assembly of the central bearing universal greasing, the same greasing натолкайте in boot sponges. Track, that the bearing got to a flute of a rubber pillow of a basic arm.

The boot is established by sponges towards landing labels on an arm.

2. Plant bearing assembly on the central and back sections of the driveshaft, - track correctness of combination of landing labels.
3. Special, a part of a remnabor, with greasing evenly grease rubber a sealant of a connecting flange. Watching correctness of combination of landing labels, the central section of a shaft and a connecting flange, densely plant the bearing by a tightening самоконтрящихся nuts.
4. Screw and tighten bolts of fastening of the hinge of Lobro. Also check assembly on existence of signs of development of leaks through a protective cover and a connecting flange.