Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Check of a condition and replacement of the directing bearing

 PERFORMANCE ORDER

1. As the directing bearing of coupling the needle bearing which is pressed in a special nest in an end face of a back pin of a cranked shaft is used. The bearing jams greasing at manufacturer and additional greasing does not need. The means of this bearing provide fixing of a forward pin of primary shaft of a transmission. Check of a condition of the bearing should be made each time at removal of components of coupling. In case of absence of confidence in fidelity of an assessment of a condition of the bearing it is necessary to replace it.

If the engine is removed from the car, corresponding from given below steps should be lowered.

2. Remove transmission (see. Head Manual transmission).
3. Remove coupling components (see. Section Removal, check of a condition and installation of components of assembly of coupling).
4. Highlighting itself a small lamp, estimate degree of wear and the general condition of the directing bearing. In case of need make replacement.

5. Removal of the bearing can be made by means of the special tool (a hammer with sliding brisk), - ask in shops of automobile accessories.

6. There is also alternative method of extraction of the bearing from the landing nest.
7. Prepare densely entering into a bearing nave a metal or wooden core (drift).

8. Fill a nest cavity under the bearing dense greasing, then start to hammer a drift into an assembly nave, - the bearing will be squeezed out of a shaft pin at the expense of hydraulic pressure developed in a cavity.

9. As an opravka when landing in a pin of a shaft of the new bearing the face head suitable on the size, or a piece of a pipe of the corresponding diameter (slightly smaller than diameter of the bearing) can be used. Before landing it is necessary to grease an external surface of the bearing slightly.

The bearing refuels in a nest the condensed party outside.

10. Establish into place coupling assembly, a transmission and all other components acting in film for the purpose of ensuring access. Track, that the corresponding fixture was tightened with demanded effort.