The device, service, repair of Mitsubishi Galant (1990 — 2001) - Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)//Mitsubishi of Galant /

Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. Turn out bolts of fastening of a semi-axis to a connecting flange of stupichny assembly of a back wheel.

3. Having accurately hooked mount, liberate the internal end of a semi-axis from a case of back differential, - try not to damage an epiploon.

4. Take a semi-axis from under the car.
5. In case of need accurately take an epiploon, having hooked it a screw-driver with the blunted flat sting.


Installation

 PERFORMANCE ORDER

1. Plant in a differential case a new epiploon, - as an opravka when landing an epiploon the face head of the suitable size, or a piece of a pipe of the corresponding diameter can be used.
2. Replace a lock ring and fill an internal pin of a semi-axis in differential, - track reliability of a zashchelkivaniye of a ring.
3. Screw bolts of fastening of a semi-axis to a connecting flange of a nave and tighten them with demanded effort (55 ÷ 65 H • м).
4. Check liquid level in differential, in case of need make the corresponding adjustment.