Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)

The hydraulic drive of coupling used on other models does not need adjustment.


Adjustment

 PERFORMANCE ORDER

1. Measure height of provision of a pedal of coupling (And). Compare result of measurement to requirements of Specifications (162 ÷ 165 mm).

Adjustment of height of provision of a pedal on these models is not represented possible and in case of an exit of results of measurement out of limits of an admissible range, pedal assembly needs replacement.

2. Several times squeeze out a pedal of coupling and estimate size of its free wheeling (till resistance emergence). If the result of measurement falls outside the limits an admissible range (17 ÷ 22 mm), make the corresponding adjustment (see further).
3. Adjustment is made by rotation located on a partition of an impellent compartment of an adjusting nut of a cover of a cable.
4. Several times squeeze out a pedal of coupling and repeat check.


Removal

 PERFORMANCE ORDER

1. Weaken a cable rotation of an adjusting castor counter-clockwise.
2. Release cable clamps.
3. Take шплинт and disconnect a cable from an executive clutch lever on RKPP case.
4. Disconnect a cable from a pedal of coupling and take it from the car, - try to remember a route of laying of assembly.


Installation

 PERFORMANCE ORDER

1. Establish a cable on the car, having laid it according to fixed in the course of dismantle of assembly by a route. Connect a cable to a pedal of coupling and the executive lever and fix it all provided clamps.

Fixing шплинт is subject to replacement without fail.

2. Grease all contact knots of hummock assembly.
3. Make adjustment of a free wheeling of a pedal (see above).