Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement of an epiploon of a leading gear wheel of back differential

Removal

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props.
2. Having marked the landing provision of components, disconnect the driveshaft from a flange of differential and tie up it a wire to elements of the bottom of the car.
3. Holding a connecting flange from a provorachivaniye, give located in its center big самоконтрящуюся a nut.
4. By means of a stripper dismantle a flange and take an epiploon of a leading gear wheel of differential.


Installation

 PERFORMANCE ORDER

1. Slightly grease with universal greasing of a sponge of a new epiploon and a surface of a connecting flange contacting to it. By means of a suitable opravka plant an epiploon on the regular place.
2. Establish a connecting flange and tighten it самоконтрящуюся a nut with demanded effort (157 ÷ 220 H • м). The torque of a provorachivaniye of a flange should make about 0.45 H • m at the new or well greased bearings.
3. Establish into place the driveshaft.