Mitsubishi Galant

1. Mark landing position of the hinge in the case of the collar. By means of special flat-nose pliers remove lock rings.
2. By means of a big clamp squeeze out of a collar bearing necks of a crosspiece: on a motionless part of a clamp the plug of the suitable size in which the neck is squeezed out is established, - in case of need knock on a collar with a hammer with soft the brisk. Having liberated a neck, take the bearing. Operating in a similar manner, remove the remained bearings and take a crosspiece.

1. Grease with universal greasing bearing necks, oil pans, sponges of boots and needle roller bearings of the replaceable kardanny hinge.

Be not overzealous, - excess of greasing can lead to mistakes at selection of lock rings and to damage of covers of bearings.

2. By means of a clamp press bearings in a collar and fix them the new lock rings equal on thickness to removed in the course of dismantle of assembly. The final zastukivaniye of necks can be made by means of a brass drift in diameter of 15 mm.
3. With the help щупа lezviyny type define gaps of landing of lock rings in the flutes. If the result of measurement falls outside the limits an admissible range (0.02 ÷ 0.06 mm), the corresponding ring is subject to replacement.