|
On models with a hydraulic drive try not to allow during performance of adjustments of a pedal of an otzhimaniye of a pusher towards the main cylinder of coupling! |
|
1. Remove rugs and mats of a floor covering, - the distance from the central part of its block to a surface of a sound-proof layer is called as height of provision of a pedal of coupling (A). |
2. Measure distance from a floor to an external surface of a block of completely released pedal. Compare result of measurement to requirements of Specifications (168 ÷ 171 mm: Mirage models and 176 ÷ 182 mm: Galant models). 3. Measure size люфта a cutting finger concerning a pedal block (the nominal rate makes 1 ÷ 3 mm). 4. If results of measurements falls outside the limits admissible value make the corresponding adjustments (see further). 5. Rotation of an adjusting bolt achieve reduction in norm of height of provision of a pedal, then strongly tighten a lock-nut. 6. On the models equipped with a control system of speed, disconnect electroconducting from the sensor switch of coupling and, rotating the last, modify as appropriate height of provision of a pedal. 7. Rotation of a pusher bring into norm size люфта a cutting finger, - in summary do not forget to tighten a lock-nut. 8. Make sure of serviceability of operation of the sensor switch of disconnection of a chain of a starter at complete squeezing of a pedal of coupling. |