Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation of hummock assembly (the Mirage model with a hummock drive of coupling)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of the kardanny hinge
   Driveshaft balancing
   Removal and installation of assembly of the central bearing of the driveshaft
   Removal and installation of back semi-axes (the AWD Galant model for 1993 вып.)
   Removal and installation of a stupichny pin of a back axis, wheel bearing and epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation a case of back differential (the AWD Galant model for 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Air removal from a hydraulic path of a drive of switching off of coupling

 PERFORMANCE ORDER

1. Pumping of a hydraulic drive of switching off of coupling should be carried out each time after removal of its components and also when liquid level in the tank of the main cylinder falls so that air gets to assembly. A pumping principle the same, as used at air removal from a brake path.
2. Fill in in the tank of the main cylinder fresh brake DOT 3 liquid.

Do not use the liquid repeatedly already extorted from system, and also, liquid, a long time stored in leaky closed container.

3. To Poddomkratta the car also establish it on props, having provided with that access to the executive cylinder of coupling fixed from the forward party of transmission assembly.
4. Remove a dustproof cap and pull on the gate of pumping of the executive cylinder the end of a plastic hose suitable on the size. The second end of a hose lower in transparent vessel partially filled with brake liquid. Track, that the cut of a hose appeared entirely is shipped in liquid.
5. Ask the assistant to squeeze out a pedal of coupling and to fix it in the bottom situation. Slightly open the gate of pumping and let out liquid from the cylinder in drain capacity. When the effluence of the liquid mixed with air bubbles will stop, again densely tighten the gate and allow to release to the assistant a pedal.
6. Continue pumping in the same manner until liquid leaving the cylinder completely will not be released from air bubbles. Constantly watch closely liquid level in the tank of the main cylinder, without allowing its excessive lowering, air dangerous by hit to the highway and data to zero of all undertaken efforts.
7. Having finished pumping, disconnect a hose and establish into place a dustproof cap. In case of need add to the tank a little more hydraulic liquid. Check serviceability of functioning of coupling.