Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and precautionary measures
   Serviceability check functioning/adjustment of system of ignition
   Check of a condition and coil replacement (ек) ignitions
   Removal and installation of the key transistor (ignition module)
   Removal and installation of the distributor of ignition (model with contactless system of ignition)
   Removal and installation of sensors of provision of cranked and distributive shaft
   Check and adjustment of installation of a corner of an advancing of ignition
   Ignition order
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Check of serviceability of functioning, removal and generator installation
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the storage battery

 PERFORMANCE ORDER

1. Since negative, disconnect from the wire battery both.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Release fixing nuts and remove a clamping level.
3. Remove the battery from the pallet and take it from an impellent compartment of the car.
4. Attentively check the adjusting pallet of the battery on existence of signs of development of corrosion.
5. At replacement track, that the replaceable battery completely corresponded on the tiporazmerny and performance data removed from the car.
6. Installation is made upside-down.