Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and precautionary measures
   Serviceability check functioning/adjustment of system of ignition
   Check of a condition and coil replacement (ек) ignitions
   Removal and installation of the key transistor (ignition module)
   Removal and installation of the distributor of ignition (model with contactless system of ignition)
   Removal and installation of sensors of provision of cranked and distributive shaft
   Check and adjustment of installation of a corner of an advancing of ignition
   Ignition order
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Check of serviceability of functioning, removal and generator installation
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and starter installation

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Disconnect electroconducting from a measuring instrument of an air stream and remove a branch pipe сапуна.
3. Give fixing nuts and remove an air inlet assembled with the resonator.
4. On the models equipped with an active suspension bracket of the ECS type disconnect from assembly of the air compressor electroconducting and an air-line. Turn out three bolts of fastening of the compressor on the chassis.
5. To Poddomkratta the car also establish it on props.
6. Remove elements of protection of a case.
7. On models of 1.5 l remove the thermofilter established under the inlet pipeline.
8. In case of need disconnect from transmission a cable of a drive of a speedometer.

9. Disconnect from a starter electroconducting.

10. Turn out fixing bolts and remove a starter.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. Track, that fixing bolts were tightened with demanded effort (31 H • м).
2. Connect a negative wire to the battery and check serviceability of functioning of system of start.