Mitsubishi Galant

1990 — 2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
- Power supply system and release
   Specifications
   Sbrasyvaniye of pressure in a power supply system
   Removal and installation of the case of a throttle
   Removal and installation of the fuel highway and injection injectors
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Check of serviceability of functioning of injectors
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of a safety valve of a fuel tank
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Removal and installation of the fuel pump/sensor of fuel consumption
   Removal and installation of assembly of an air purifier
   Release system
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Release system

It is necessary to start service of system of release only after complete cooling of its components, - remember that the surface of the catalytic converter in use the car can heat up to very high temperatures! Track reliability of fixing of the car in the lifted situation.


General information

Models considered in the real Management are completed with system of production of the fulfilled gases of one of two types. In one design for a joint among themselves sections of system are used equipped with sealing laying and flange connections pulled together by bolts, in another sliding homutny couplers are applied.

In view of that in use the car components of system of production of the fulfilled gases constantly are exposed to aggressive influences of environment and high temperatures, components of assembly can appear “tightly become attached” to each other therefore, before starting a fixture otpuskaniye, it is necessary to impregnate joints of the corresponding sections with getting oil. In especially hard cases it is necessary to use a hacksaw, a chisel or autogenous cutting. It will be most correct to charge performance of replacement of components of system to specialists of car-care center.

Check of a condition of components

 PERFORMANCE ORDER

1. The condition of components of system of production of the fulfilled gases should be checked on a regular basis according to the Schedule of routine maintenance of the car (see. Head of Control and routine maintenance).
2. To Poddomkratta the car also establish it on props. Remove limiting sector of the review and access thermofilters.
3. Check should be begun with survey of a joint of a reception pipe of system of production of the fulfilled gases with a final collector / turbokompressor.
4. Attentively examine system on all its length, checking sections and components on existence of deformations, traces of the leaks, the dispersed seams and other defects of a mechanical order.
5. Estimate a condition rubber подвесов system support. Defective units replace.