Mitsubishi Galant

1990 — 2001 of release

Repair and car operation

Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
- Cooling and heating systems
   Antifreeze - general information
   Check of serviceability of functioning and thermostat
   Check of a condition of the fan of system of cooling
   Removal and installation of a radiator of system of cooling
   Check of a condition of the water pump
   Removal and installation of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Replacement of the electromotor of a drive of the fan of a heater
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of driving cables
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Check of a condition of the fan of system of cooling

Try not to touch blades of a krylchatka with hands, the tool and clothes elements. In order to avoid receiving a trauma or equipment damage, do not start the engine at the faulty fan. Do not undertake attempts to repair the broken blades of a krylchatka, - change it assembled!



1. Check a krylchatka of the fan on existence of cracks, special attention giving to a condition of the bases of blades. The defective krylchatka is subject to replacement without fail!
2. Check assembly of coupling of the fan on existence of signs of development of leaks, in case of need make replacement.
3. Shake a krylchatka in the longitudinal direction, - in case of identification люфта replace coupling assembly.
4. Manually повращайте a krylchatka, - the certain resistance increasing with temperature increase of the engine should be felt. If the krylchatka rotates too freely, or does not rotate at all, replace coupling assembly.
5. The description of procedures of removal and installation of ventilyatorny assembly is provided in the Section Removal and installation of the fan of system of cooling of the engine.