Mitsubishi Galant

1990 — 2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Governing bodies
+ Settings and routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
- Control systems of the engine
   Specifications
   System of operated ventilation of a case (PCV) - the general information, check of a condition and replacement of components
   System of catching of fuel evaporations (EVAP) - the general information, check of a condition and replacement of components
   System of a retsirkulyatsiya of the fulfilled gases (EGR) - the general information, check of a condition and replacement of components
   System of onboard diagnostics (OBD) - a principle of functioning and codes of malfunctions
   Replacement of the module of management (ECM/PCM)
   Information sensors and actuation mechanisms - the general information, check of serviceability of functioning, removal and installation
   The catalytic converter - the general information, check of a condition and replacement
+ Manual transmission
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement of the module of management (ECM/PCM)

In order to avoid failure of elements ROM at service of ECM/PCM it is necessary to put on a special bracelet for removal of a static electricity!

The Mirage models (all) and Galant since 1999 вып.

 PERFORMANCE ORDER

1. On these PCM models it is located in the lower part of a rack of a forward passenger door of the car (over a forward overlay of a threshold).

2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. Disconnect electroconducting, release clamps and remove PCM assembly.
4. Installation is made upside-down.

Galant 1994 ÷ 1998 models of вып.

 PERFORMANCE ORDER

1. Location of the module of management on the Galant 1994 ÷ 1998 models of вып. it is shown on an illustration.

2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. Remove both lateral sections of the central console.
4. Disconnect electroconducting, dismantle elements of fixture and remove assembly of the module of management from the car.
5. Installation is made upside-down.


Diamante models (all) and Galant 1990 ÷ 1993 of вып.

 PERFORMANCE ORDER

1. Location of the module of management on the Diamante and Galant 1990 ÷ 1993 models of вып. it is shown on illustrations.

2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. At the corresponding complete set of the car disconnect safety cushions.
4. Remove the bottom section of furnish of the dashboard from the passenger, also remove an air line sleeve.
5. Remove the drummer of the lock of a ware box, assembly of a box of an illustration its external casing. Turn out the screw located under a ware box.
6. Disconnect electroconducting, dismantle fixture and remove PCM.
7. Installation is made upside-down.